Canon BU-51H Посібник із швидкого старту - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Цифрова камера Canon BU-51H. Canon BU-51H 8 сторінок. Canon remote control pan-tilt system
Також для Canon BU-51H: Кишеньковий посібник (22 сторінок), Посібник користувача (2 сторінок), Кишеньковий посібник (22 сторінок), Посібник з дистанційного керування (2 сторінок), Брошура та технічні характеристики (4 сторінок)

Canon BU Series PTZ Camera Systems

Step 4: BU-47H Camera System ONLY

Carefully loosen the four hex screws from the housing on the back of the pan/tilt base. 18 inches of flexible plastic

conduit is supplied with the camera, along with a coupler connected to the weatherproof housing on the back of the

camera. The opening in the back of the housing is 1.67 inches in diameter if it is determined that another type of

weatherproof conduit is required for the specific installation.

Connect the positive (+) and negative (-) connections to the screw terminals on the camera. Connect the BNC

cable for HD-SDI to the SDI output connector. If sync and/or composite video is required for the installation run

additional coax cables to the Sync and VBS ports on the back of the camera.

Next, remove the 12-pin connector that was supplied with the BU-47H by grasping the collar and pulling outward.

Locate the 12-pin to RJ-45 adapter cable (see the diagram below), and connect the 12-pin connector to the camera.

Plug in the Cat. 5e cable that was run to the camera and connect the RJ-45 connector to the other end of the 12-pin

cable. Note: the RS-232 to RS-422 converter should be placed by the Vaddio joystick controller (see Figure 2).

NOTE: Be sure to turn on the power switch (labeled "POWER SW" in the diagram below) on the pan/tilt head,

before putting the housing back on the pan/tilt base.

Step 4: BU-51H

Connect the RJ-45 to DB-9 adapter to the CONTROL port on the back of the pan/tilt head. Connect the power and

control cables that were supplied with the BU-51H camera into the appropriate ports on the camera and pan/tilt

head. Refer to the Canon manual for additional details on cable placement. Connect the AC cord to the back of the

pan/tilt head.

Step 5:

After completing the installation of the camera, connect the Cat. 5e cabling to the back of the Vaddio joystick

controller. Follow the programming instructions provided with the Vaddio joystick controller in order for it to

recognize the Canon BU series camera.

Canon BU-Series PTZ Camera Installation and User Guide 341-909 Rev. C

BU-47H

Camera

Cable

Enlarged

BU-51H

Camera

Connect to Control

Connector

Cat. 5e cable from

ProductionVIEW

Control Port

Connect Control

Adapter to BU-51

Control Port

Page 5 of 8