Canon CR-X500 2A Інструкція з експлуатації - Сторінка 19

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Цифрова камера Canon CR-X500 2A. Canon CR-X500 2A 25 сторінок. Remote camera

Symptom

Communication is not possible with the

operation unit.

Camera control does not work.

No video is displayed although the pan-

tilt head can be operated.

The pan-tilt head does not move.

The custom picture settings cannot be

selected using the operation unit.

Site where check is

required

Installation site

• Check that each cable is connected correctly.

Installation site

• Check the power to the pan-tilt head.

• Check that the control cable for pan-tilt head and the cable for camera are connected correctly.

• Conduct a continuity check for broken cable wires, etc.

Installation site

• Conduct a continuity check for broken cable wires, etc. (Disconnect the BNC and check the video

from the pan-tilt head.)

Installation site

• This may be due to an outside factor such as strong wind or some obstacle.

Check and remove any obstructing factors, and perform the operation again.

Installation site

• [Activate Other Settings] in the custom picture settings was set to [Off]. Turn the camera off and

then on again.

Additional information

Check and confirm