Boca Flasher HPCCS Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Прожектор Boca Flasher HPCCS. Boca Flasher HPCCS 7 сторінок.
Друкувати сторінку1. Install Fixed Clips into Substrate
1a.
Determine layout of fixture or composition of
fixtures and locate appropriate clip location.
CLIP MUST BE A MINIMUM OF 4.5"
FROM END-CAP TO ALLOW CLEARANCE OF
MOLDED CORDS.
2. Install Fixture into Fixed Clips
Angle fixture
2a.
into opening,
pushing clip
wider as you
push
3. Install Hinge Clips
1b.
1c.
Tab on side of
2b.
clip should go in
notch at the top
of the fixture
3a.
Page 3 of 7
INSTALLATION INSTRUCTIONS
1. Screws not provided by
2. Boca Flasher recommends wide
3. Length of screw will vary
4. For outdoor installations,
5. One foot fixtures only require
Clip will securely
2c.
snap into place
snap!
3b.
Hinge clips come installed on
the fixture. Therefore it is easy to
determine where to predrill the
holes into the substrate before
doing so. Installing is only a matter
of drilling in the proper screws,
recommended.
HPCCS
Screw Information:
Boca Flasher.
washer flat head Philips #8
screw (not to exceed .418".
depending on mounting
surface.
installer should use a screw
with weatherproof coating.
one hinge bracket.
Installing Hinge Clips: