Domus Viento-48 Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Вентилятор Domus Viento-48. Domus Viento-48 17 сторінок.

Step 6

•

Assemble the blade holders to the blades using the nuts, washers and bolts.

•

Attach the blade holders to the fans with screws and spring washers provided.

•

If more than one fan is being installed at the same time, be careful not to mix the blades as each set is weight

matched and balanced to the fan.

•

Mixing the blades will cause the fan to wobble and this is not covered under warranty.

•

Screw the decorative plate into the threaded hole on the bottom of the fan (if the light is not used and if it is not

already attached).

NOTE:

To reduce the risk of injury, do NOT bend the blade holder during installation, balancing or cleaning of the

blades. Do not insert foreign objects on or between rotating fan blades.

Step 7 - Installing light bulbs (fans with light kits only)

•

Remove the lamp Shade glass carefully. Gently pull down the glass shade as it is held on by spring clips.

•

Insert the CFL bulb (1x15W "MAX") in the holder. Always use a pair of gloves or keep your hands clean when

installing or replacing CFL bulbs.

•

LED lamps are also permitted.

•

Replace the glass by bringing the spring clips inwards as you position the glass back into place

•

Please ensure all the clips are inside the glass to stop the glass from possibly falling.

NOTE:

Ensure the power is switched off before fitting the bulbs.

Note: The Ceiling Fan must be installed by a licensed Electrician. Ensure the power is switched off before fitting this ceiling fan.

For any questions, please call Domus® on (02) 9554 9600, Monday to Friday 9am – 5pm EST.

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600

Fax: 02 9554 9433

www.domuslighting.com

Installation Manual