DOMUS LINE 103377492 Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Світильник DOMUS LINE 103377492. DOMUS LINE 103377492 17 сторінок.

INSTALLATION MANUAL

TECHNICAL DATA

Input voltage:

Output voltage:

Maximum applicable load: 36W (with 12Vdc power supply)

NOTES:

- DOTTI IR may work as a limit switch or "ON/OFF" + Dimmer

switch depending on how it is set. By default DOTTI IR is set to

limit switch mode.

- Before proceeding to install the device, decide which mode to

use DOTTI IR in.

- To switch from one mode to another, power up the sensor

connecting the "IN" connector (C) to a 12Vdc or 24Vdc

converter and press button (1) as shown in figure 2.

ATTENTION:

Before proceeding to mount the version set as limit switch,

check the operating distance according to the door colour.

12–24Vdc

12-24Vdc

72W (with 24Vdc power supply)

- DOTTI IR can be installed with the cables in an axial or radial

position in relation to the mounting surface. For installations

with the power cable in the axial position, drill a ø ≥ 9mm hole

in the mounting surface as shown in the example in figure 1.

For special requirements, it is nonetheless possible to drill the

power cable outlet hole in other positions as long as they do

not interfere with the integrity of the cable and/or connector

installed on it.

- Fix the bracket (A) in the required position using the screws

supplied (B).

- Connect DOTTI IR only to a safe power supply with 12Vdc or

24Vdc stabilised voltage (sold separately)

- For connection to a 24Vdc power supply (figure 4) insert

connector (C) on the DOTTI IR input cable (IN) to one of the

free slots on the distributor (N) on the Converter secondary

cable; then connect connector (D) on the DOTTI IR output cable

(OUT) to connector (E) on the Micro-24 distributor cable (F).

- For connection to a 12Vdc power supply (figure 5) use the

adapter cable (G) and the Micro12 distributor (H) sold

separately.