DOMUS LINE CUBIT D-MOTION Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Світильник DOMUS LINE CUBIT D-MOTION. DOMUS LINE CUBIT D-MOTION 20 сторінок.

INSTALLATION MANUAL

This installation manual contains instructions valid for all

configurations of the SMALLY-CUBIT-QUADRUM D-MOTION

device

WARNING

Safety is guaranteed if these instructions are followed and

therefore they must be kept. Installation may require the

involvement of qualified personnel. Before proceeding with

installation of the device, ensure that the environmental conditions

are in conformity with and suitable for the characteristics of the

product. Before any operation on the device disconnect mains

power.

CONFIGURATIONS

The installation and operation instructions in this manual are valid

for all configurations of the SMALLY-CUBIT-QUADRUM D-MOTION

device, between which there are some differences. The SMALLY

Plus , SMALLY XS Plus, CUBIT Plus D-MOTION and QUADRUM Plus

D-MOTION (Plug & Play) models refer to the configurations of the

devices that have a built-in disconnectable power cable. The

SMALLY IP44, SMALLY XS IP44, CUBIT IP44 and QUADRUM IP44

D-MOTION models refer to the configurations of the splash-proof

devices.

All of the SMALLY D-MOTION models can also be fitted with

hardware for surface installation. The SP configuration refers to the

devices with symmetrical surface support.

The OB configuration refers to the devices with asymmetrical

surface support. The ML configuration refers to devices for for flush

mount installation on 0.7 mm thick (min.) metal surfaces.

FLUSH INSTALLATION ON WOOD PANELS

The SMALLY-CUBIT-QUADRUM D-MOTION collection devices can

be flush mounted either on a pass-through hole or on a closed-end

hole in wood panels.

The installation can be carried out with the light power supply

cable in both an axial or radial position with respect to the

installation surface. In the event of a specific requirement a power

wire exit hole can nevertheless be drilled in other positions as long

as it does not compromise the integrity of the wire and/or the

connector installed on it.

- To flush mount the device, bore a ø 57mm hole ≥ 12mm deep on

the installation surface and then, if necessary, bore a ø ≥ 8mm exit

hole for the power supply cable as illustrated in figure 1.

- Insert the power supply cable (A) into the hole and then install

the light, applying light pressure until it is completely fitted as

illustrated in figure 2.