DOMUS LINE CUBIT TW Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Світильник DOMUS LINE CUBIT TW. DOMUS LINE CUBIT TW 12 сторінок.

INSTALLATION MANUAL

FLUSH INSTALLATION ON METAL SURFACES

The SMALLY ML devices can be flush mounted on 0.7 mm thick (min.)

metal surfaces and on a ø 57 mm hole as illustrated in figure 3.

- The light must be anchored to the metallic bracket by inserting first one

spring and then the other, applying slight pressure until completely fitted

as illustrated in figure 4.

CONNECTION OF THE SMALLY-CUBIT-QUADRUM Plus (Plug & Play)

POWER CABLE

The SMALLY Plus, SMALLY XS Plus, CUBIT Plus, QUADRUM Plus (Plug &

Play) models refer to the configurations of the devices that have a built-in

disconnectable power cable. The SMALLY Plus, SMALLY XS Plus, CUBIT Plus

and QUADRUM Plus power lead can be disconnected and allows the device

to be easily disconnected and removed if necessary. Follow the installation

instructions for connection of the cable to the device.

- For connection of the power cable to the device, insert the cable

connector (B) into the slot (C) on the device, until the safety hook (D) is

press-fitted into place as illustrated in figure 5.

- To remove the device power cable, press the safety release (D) slightly

with your finger and extract the connector (B) from the slot (C) on the

device as illustrated in figure 5.

All of the SMALLY models can be surface mounted with the aid of specific

supports. The installation can be carried out with the light power supply

cable in both an axial or radial position with respect to the installation

surface. In the event of a specific requirement a power wire exit hole can

nevertheless be drilled in other positions as long as it does not compromise

the integrity of the wire and/or the connector installed on it.

- Secure the plastic bracket (E) to the installation surface with the included

screws (F); insert the light (G) into the plastic support, applying light

pressure until it is completely fitted as illustrated in figure 6.

- If necessary, bore a ø ≥ 8mm exit hole for the power supply cable as

illustrated in figure 7.

CONNECTING THE DEVICE TO THE POWER SUPPLY _ static light

configuration

- Connect SMALLY-CUBIT-QUADRUM only to a safe power supply with

12Vdc stabilised voltage (sold separately) and with power at least 10%

higher than the total load. For the total load calculation check plate data

printed on the product label.

- If more than one device must be connected to the power supply ensure

that the total sum of the power absorbed by the devices (check the plate

data shown on the product label) does not exceed the maximum power

permitted by the Converter.