American Standard Newbern Vanity Top 7820.800 Інструкція зі збирання та встановлення - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція зі збирання та встановлення для Внутрішнє оздоблення приміщень American Standard Newbern Vanity Top 7820.800. American Standard Newbern Vanity Top 7820.800 3 сторінки. American standard vanity installation instruction
Друкувати сторінку
Installing the Newbern Top...
Two people recommended for this installation
Mount the drain assembly (not included) on the sink. Be certain to apply
a bead of sealing putty on the underside of the drain (Part "A") in order to
ensure a watertight seal between the sink and drain. Remove excess
putty after installing the drain on the sink.
Apply a bead of silicone adhesive to the rim of the vanity. Place the
Newbern top centered left to right on the vanity and with the back edge of
the top even with the rear of the vanity. Clean up any excess silicone.
Place top back on vanity and, connect the trap to the drain assembly
hand tight to check alignment. It may be necessary to cut off part of the
tailpiece (area "B") or part horizontal leg of the trap (area "C").
Connect hot and cold supply lines to the shut off valves. Tighten trap
joints for watertight assembly.
27-1/2"
ANCHORING
578mm
HOLES (3)
- 2 -
FIGURE 4
Using a 3/8" O.D. drill, drill 3 anchoring
holes, equally spaced, in back support of
vanity (see Figure 4).
Continue with installation appropriate for
top and sink options chosen.
A
C
B
7301050-100 Rev. C