Baroness LM2700 Технічна інформація - Сторінка 6
Переглянути онлайн або завантажити pdf Технічна інформація для Газонокосарка Baroness LM2700. Baroness LM2700 6 сторінок. Backlapping
Також для Baroness LM2700: Технічна інформація (5 сторінок)
Друкувати сторінку
Next, move on to the third unit and repeat the process.
With the third cylinder still rotating, go back to the second one and turn it off.
Work your way around all 5 cutting units as described above so that you only ever have two units
rotating at once, as having the cylinders running dry for a prolonged period of time can cause damage to
the blades.
Once the cutting units are dry, check
the cut using a strip of paper.
Once all 5 units have been back-lapped you
will need to thoroughly wash the back-
lapping paste from the blades.
The best way to do this is to turn the units
on one at a time, and with them rotating
direct a jet of water at them. Move the
hose from left to right until all of the paste
is removed.
Turn each unit off after you have finished
washing it before moving on to the next
unit.
Normally after back-lapping, no further
adjustments are necessary, however, you
might need to readjust the cut slightly by
bring the cylinder down onto the bottom
blade using the adjusters as shown.
If after back-lapping you still cannot get
the unit to cut properly then you might
have to repeat the back-lapping process or
even consider having the units re-ground.