American Standard Studio 30" Vanity 9205.030.339 Інструкція зі збирання та встановлення - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція зі збирання та встановлення для Внутрішнє оздоблення приміщень American Standard Studio 30" Vanity 9205.030.339. American Standard Studio 30" Vanity 9205.030.339 4 сторінки. 30" vanity

Друкувати сторінку

MARBLE TOP 9205.130.250 WITH STUDIO 0614 UNDERMOUNT SINK

Two people recommended for this installation

NOTE: Marble top comes pre-cut for the Studio Under Counter mount sink and 8"

faucet spread. Also it is strongly recommended that the marble top be sealed after

installation and prior to use.

Mount the drain assembly (not included) on the sink. Be certain to apply a bead of

sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal

between the sink and drain. Remove excess putty after installing the drain on the sink.

Turn the marble top upside down and place it on a clean, scratch

resistant surface. Apply a bead of silicone adhesive to the rim of

the sink. Center the sink over the cutout and (secure it to the top

using the mounting kit provided).

NOTE:

Use the 4 brackets supplied with the sink mounting kit

and the 4 screws supplied with the marble top to secure the sink to

the underside of the marble top.

Turn the top right-side up and install the faucet per the manufacturer's instructions.

Apply a bead of silicone adhesive to the rim of the vanity. Place the marble top

centered left to right on the vanity and with the back edge of the top even with the

rear of the vanity. Clean up any excess silicone.

Connect the trap to the drain assembly hand tight to check alignment. It may be

necessary to cut off part of the tailpiece (area "A") or part horizontal leg of the

trap (area "B").

Connect hot and cold supply lines to the shut off valves. Tighten trap joints for

watertight assembly.

Care and Cleaning of Vanity

Clean the product by using soft, slightly damp cloth. Buff the product by using a soft dry cloth. Avoid using silicone

cleaners and waxes.

Clean up excess water and spills immediately. Use a blotting rather than a wiping action. Water left over a long period of

time will cause white spots in the finish.

NOTE: Please note that some chemicals may damage the finish. Take care to avoid the following: iodine, hair dye, after

shave lotion, shaving cream, alcohol, perfume, Lestoil®, Lysol Tub and Tile Cleaner®, Lysol Spray Disinfectant®, Dow

Disinfectant®, acetone, paint remover, Formula 409®, Tile-X®, and Nair®.

Care and Cleaning of the Marble Vanity Top

Marble is porous and easily stained. Wipe off anything spilled on it immediately. It should be washed or cleaned regularly

with fresh warm water and a non-abrasive clean cloth. Also, using a non-abrasive, neutral (pH balanced) cleaner will help

remove dirt and grime, but it is recommended to first try warm water only.

Marble should be sealed regularly with a good quality marble sealer. Marble sealers are available at most retail home

supply stores. Follow the instructions on the sealer container for proper application and frequency of use. The sealer acts

as a stain inhibitor and prevents most stains and soil from being absorbed into the porous surface, but it is NOT a

guarantee against staining. All spills should be cleaned immediately. Avoid contact with all oils and petroleum-based

products. Also, avoid contact with all acid or caustic products such as vinegar, citrus or fruit juices, soda, chlorine, and nail

polish remover. If the marble is well sealed, the warm water and non-abrasive cloth should keep it clean.

- 3 -

7 70 0 13 - 10 0