American Standard Colony Oval 1742 Series Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Ванни American Standard Colony Oval 1742 Series. American Standard Colony Oval 1742 Series 4 сторінки. American standard whirlpool/bathing pool installation instructions
Друкувати сторінкуFRAMING AND INSTALLATION
THE VARIETY OF INSTALLATIONS POSSIBLE FOR THIS BATH MAY REQUIRE FRAMING PROCEDURES OTHER THAN THOSE SHOWN.
LOCATE STUDS AS REQUIRED. INSURE ROUGH DIMENSIONS ARE PROPER, PLUMB AND SQUARE. FOR WHIRLPOOLS, PROVISION MUST
BE MADE IN ALL INSTALLATIONS FOR AN ACCESS OPENING FOR SERVICING PUMP AND CONTROLS.
THE FOLLOWING PROCEDURE MUST BE USED FOR ALL INSTALLATIONS: STRINGER OR PIER HEIGHT SHOULD BE AS INDICATED.
THIS BATH MUST BE SUPPORTED ALONG ITS ENTIRE BOTTOM. We recommend the use of mortar as bedding material
(sand is not recommended). Apply enough bedding to support the complete bottom of the bath. After the bedding has been
poured, and before it sets, position whirlpool or bath within recess until the rim is leveled against the leveling stringers (see
"Typical Recess Installation") shown below. The rim of the bath MUST NOT support weight. Allow the bedding material to
completely harden before applying weight to the rim or bottom of the bath. Any finish material such as tile or wall board must
be self-supporting if it contacts the deck of the bath.
SUGGESTED INSTALLATION
METHOD
LEVELING SURFACE
WATERPROOF
SEALANT
753571-100
BATH
TYPICAL INSTALLATION
AS DES IRED
*39
(991 mm)
CUTOUT
21-7/8
(556mm)
AS DES IRED
* S E E C U T O U T T E M P L A T E P R O V I D E D
U N L E S S A N A C C E S S O P E N I N G O F A T L E A S T
1 2 " X 2 4 " ( 3 0 5 X 6 1 0 m m ) I S P R O V I D E D ,
W A R R A N T Y S E R V I C E W I L L N O T B E P E R F O R M E D .
(2)
IT MAY BE NECESSARY TO
NOTCH THE DECK SURFACE
TO ACCOMMODATE THE
WHIRLPOOL ON/OFF SWITCH
AND/OR THE AIR CONTROL
DURING INSTALLATION
*69
(1753 mm)
CUTOUT
24
(610mm)
ACCESS PANEL
12
(305 mm)