D3D D3DONEPRO Посібник з першого налаштування - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з першого налаштування для 3D-принтери D3D D3DONEPRO. D3D D3DONEPRO 6 сторінок.

19: load filament. click on the CH Filament icon, wait for the head to reach 200°c. Once the temperature is

200°c, press the Fast EXTRUDE button (lower part of the screen) to extrude filament. you will see the

filament been pushed through the bowden tube. When the filament is arriving close to the head, then

press the Slow Extrude button and wait to the material to be extruded before press on the BACK icon to

return to the principal MENU

20: Insert SD Card on the left panel. push it to the maximum. select a gcode and start printing.

21:Install cura 15.04.03 from the directory on the sd card.

22:for any type of issue or dubt contact [email protected] customer care service will help you in very

short time