Da-Lite 29530 Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Проекційний екран Da-Lite 29530. Da-Lite 29530 14 сторінок.
Друкувати сторінку
Installation (continued)
10. At the unrolled screen surface (A), peel back the protective
paper approximately 3/4" on the top and the bottom. This will
allow the frame to be attached easily to the screen surface.
NOTE: Do not remove the protective paper completely. This
will be done at the end of the screen installation in order to
protect the surface during the hanging process.
Da-Lite recommends that the provided gloves (E) be worn at
this time in order to prevent damage to the screen surface and
to provide grip while lifting.
11. Center the first rubber gasket (F) on the screen surface edge
and press it into place starting at one end. Repeat this step
for the three remaining sides of the screen.
12. Place the frame sections (G) around the screen surface (A).
Attach to frame (G) over the rubber gasket (F) with set screws
facing upwards. Use a rubber mallet to gently tap the screen
frame into place if needed (See Figure 5)
Corner Brackets
Hoisting Brackets
Frame
Section
Pre-Attached
Seam Bracket
Hoisting Bracket
Rubber Gasket
Hoisting Bracket
Seam Bracket
13. Place the hoisting bracket (H) in the center of the top and
bottom sections of the screen frame. Attach to frame using
the provided cap screws (I) and a 3/16" hex key.
14. Starting from the center on each side, tighten all set screws
on all four sides of the frame using the 1/8" hex key.
Approximately two threads should be visible on each set
screw when properly tightened.
15. Prepare to attach the seam brackets (J) and corner brackets
(K) by carefully sliding the 3/8" x 1/2" hex head screws (L)
down the frame channel (two bolts on either side of the seam
and two on each side of each corner).
16. Carefully slide the seam bracket (J) under the assembled
frame, aligning the bracket and 3/8" screws (L) across the
seam. Secure using the 3/8" thin hex nuts (M) and tighten
completely.
17. Repeat for corner brackets (K).
Rubber Gasket
Figure 5
Hoisting Bracket
Frame
Section
Screen
(Projector Side)
Set Screw
Cap
Screw
9