Da-Lite ADVANTAGE ELECTROL Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Проекційний екран Da-Lite ADVANTAGE ELECTROL. Da-Lite ADVANTAGE ELECTROL 12 сторінок. Tensioned large
Також для Da-Lite ADVANTAGE ELECTROL: Інструкція з експлуатації (12 сторінок), Посібник інсталятора (2 сторінок), Інструкція з експлуатації (4 сторінок), Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (16 сторінок)

SCREEN AND ROLLER ASSEMBLY INSTALLATION

Follow these steps if your screen and roller assembly was ordered separately from the case.

1. Remove the access door. First, remove the 2 screws from the

ends. Be sure to support the door during this step to avoid

injury. Then lift the door slightly and pull away from the edge of

the case (Figure 1).

2. Carefully unpack screen and roller assembly. Leave packing

paper on roller.

3. To install screen and roller assembly, loosen (but do not

remove) four 1/4-20 nuts securing pin end bracket (opposite

end from the junction box) to the case housing. Slide the pin

end bracket towards the end of the case (Figure 2).

4. Insert the motor end square shaft into the motor end bracket

(junction box end) and secure with the clip (Figure 3).

5. Moving to the pin end of the case, slide the pin end bracket

until the hole fits securely over the pin. Tighten the 1/4-20 nuts

on the pin end bracket securely (Figure 2).

Access Door Screws

Foam Blocks

Figure 1

6. Complete electrical hook-up by snapping motor wire connector

into case connector (Figure 3).

7. Carefully remove paper and tape from roller assembly. DO NOT

use a knife or sharp object to cut tape; you will damage the

screen. Pull orange string.

8. Test installation by running screen up and down a few times.

Be prepared to stop screen should any objects obstruct the

movement of the screen. To prevent damage to the motor, the

standard duty cycle is 1 minute on and 3 minutes off.

9. Re-install the access door. Procedure is the reverse of step 1

listed above.

1/4-20 Nuts

Figure 2

Clip

Motor Power

Connector

Motor

Motor Mount

Bracket

Figure 3