Da-Lite ADVANTAGE ELECTROL Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Проекційний екран Da-Lite ADVANTAGE ELECTROL. Da-Lite ADVANTAGE ELECTROL 16 сторінок. Tensioned large
Також для Da-Lite ADVANTAGE ELECTROL: Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (12 сторінок), Посібник інсталятора (2 сторінок), Інструкція з експлуатації (4 сторінок), Інструкція з експлуатації (12 сторінок)

Tools Required for Installation

#2 Phillips Screwdriver

1. Carefully unpack case from shipping carton.

2. Set aside the Installation Kit. Items inside will be used during

installation.

3. Make sure to recheck measurement of case for proper

installation clearance.

4. Remove any protective foam covering the outside of

the case.

1. Hang case and attach to support structure with bolts.

See Suggested Methods of Installation.

2. Tighten bolts until trim flange is flush with ceiling.

NOTE: For proper operation, case must be levelled side to

side and front to back.

3. Remove 2 screws to open junction box. Install electrical

connections that apply to your unit. Make sure to review the

wiring diagram for proper hook up. Replace junction box

cover and secure with 2 screws.

NOTE: Must be installed in accordance with the requirements

of the Local Building Codes, the Canadian Electrical Code

(CEC), CAN/CSA C22.1 and the National Electric Code (NEC),

NFPA 70.

1/2" Open Wrench

or Socket Driver

5. For shipping purposes, foam is also inserted between the

roller brackets and end caps (Figure 1). Remove these foam

blocks from the ends.

6. Remove the hanger brackets from the top of the case using a

1/2" wrench. Do not discard the hardware; it will be used

during case installation to re-attach the hanger brackets for

mounting.

If your case was ordered in advance of the screen and

roller assembly, your installation is now complete.

Continue to step 4 if your Advantage Electrol was ordered

as a complete unit.

4. Carefully remove paper and tape from roller assembly.

DO NOT use a knife or sharp object to cut tape; you will

damage the screen. Pull orange string..

5. Test installation by running screen up and down a few times.

Be prepared to stop screen should any objects obstruct the

movement of the screen. To prevent damage to the motor,

the standard duty cycle is 1 minute on and 3 minutes off.