Da-Lite ASCENDER ELECTROL Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Проекційний екран Da-Lite ASCENDER ELECTROL. Da-Lite ASCENDER ELECTROL 8 сторінок.
Також для Da-Lite ASCENDER ELECTROL: Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (6 сторінок)
Друкувати сторінку
Screen Operation (continued)
1.
The Ascender screen can be operated by the included wall
switch or by optional remote controls (IR or RF).
2. To raise the screen, simply push and release the wall switch. The
screen will stop at its preset position. If you push the switch a
second time while it is rising, the screen will stop. By pushing the
switch a third time the screen will retract and close.
3. To lower the screen from the fully up position, press and release
the wall switch and the screen will retract and close.
4. Test the screen by running it up and down a few times. Be
prepared to stop the screen if needed.
Ascender Electrol® Installation
1.
For installations where the Ascender will be set on the floor, the
box must be secured to floor in at least six places (recommended
hardware is #12 x 2" L wood screws)(Figure 1).
Floor
Screw Box Into Floor Stud
Figure 1
CAUTION! Excessive continuous operation may cause
overheating. If this happens, the motor will shut off until it
cools to normal operating temperature. Standard duty cycle
is 1 min. on / 15 min. off.
ATTENTION! Le fonctionnement continu et excessif peut
provoquer une surchauffe et l'arrêt du moteur. Si cela se
produit, les moteurs s'arrêteront jusqu'à qu'ils se soient
refroidis à la température normale de fonctionnement. Le
cycle de fonctionnement normal est de 1 min. en marche / 15
min. à l'arrêt.
2. For installations where the Ascender will be recessed into the
floor, the box must be secured in at least six places
(recommended hardware is #12 x 2" L wood screws)(Figure2).
Floor
Box Frame Support
Figure 2
3