1800doorbell DA50L-A Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари 1800doorbell DA50L-A. 1800doorbell DA50L-A 2 сторінки. Wireless entrance alert kit

Друкувати сторінку

The DA50LR-A comes with a 12VDC plug-in power supply with

5-feet of cord. This unit can be mounted on any wall where there is

an electrical outlet located within 500 feet of the transmitter. The

DA50LR-A is for indoor locations only. The DA50LR-A may be

tabletop or wall mounted.

Six dip switches are located on the backside of the unit. To pair the

receiver with the transmitter, dip switch positions #1-4 on the

receiver must match the settings of dip switches #1-4 .on the

transmitter.

The DA50LR-A is provided with internal speaker and auxiliary

speaker output terminals marked SPKR. The volume knob controls

both the internal and auxiliary speakers.

A set of additional 12VDC output terminals are provided for additional buzzers, strobe lights, sirens, or other

12VDCdevices. Please observe marked (+/-) polarity when attaching additional devices. The output time may be set

for 1-second or 5-seconds by dip switch in position 5 on the receiver only. The OFF (down) position is 1- second and

ON (up) position is 5-seconds.

Misc. Notes & Tips:

• Dip switch position 6 in the receiver is not used at this time.

• If the unit rings too often or picks up every person (example, a large group of people are walking in at the same

time) as they come in, you can add a delay of 5-seconds between rings to receiver unit by moving dip switch #5

to the ON position.

• The amount of time power is supplied to the 12VDC output is also controlled by dip switch #5 on the receiver. The

OFF setting will supply 1 second of power. Changing this to the ON position will supply 5-seconds of continuous

power to the receiver.

• DO NOT mount the transmitter or receiver directly on a metal surface as this may harm the e ective

transmission range

• Avoid placing the sensor/transmitter near a heating or cooling air duct and in direct sunlight. This may cause false

signals or no signal from the detector.

*IMPORTANT: Before changing and dip switches on the receiver or transmitter, power must be disconnected from BOTH

UNITS.

Product Support & Warranty Information:

Rodann Electronics Mfg.

LIMITED WARRANTY

Not Covered

WARNING This device complies with Part 15 of the FCC rules, operation of this device is subject to the following conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation. This device complies with

gives you speciﬁc legal rights, and you may also have other rights which vary from state to state.

1800

DOORBELL

This Product is Sold & Marketed by:

a LHE, Inc. Company

9655 Florida Mining Blvd. W., Ste 401

Jacksonville, FL 32257

www.1800doorbell.com

oorbell

Speaker output

12VDC output

RSS-210 of Industry Canada. This warranty

Dip switches

#1-6