American Standard Low Profile Studio S Toilet Elongated Right Height with Seat 2548A Інструкція з монтажу Догляд та обслуговування - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу Догляд та обслуговування для Туалети American Standard Low Profile Studio S Toilet Elongated Right Height with Seat 2548A. American Standard Low Profile Studio S Toilet Elongated Right Height with Seat 2548A 4 сторінки.

Друкувати сторінку
American Standard Low Profile Studio S Toilet Elongated Right Height with Seat 2548A Інструкція з монтажу Догляд та обслуговування
3

INSTALL CLOSET BOLTS

Install closet bolts in flange channel, turn 90 ° , and
slide into place 6" (152 mm) apart and parallel to wall.
CLOSET
FLANGE
CLOSET
BOLTS
5

WATER SUPPLY CONNECTION TO TOILET

CONNECT SUPPLY HOSE TO SYSTEM
Connect water supply hose to connection in back of
toilet for supply line outside of toilet. See Figure 1.
Note: This will ease installation of supply hose
once toilet is installed.
For supply line that is installed behind the toilet,
connect supply hose to Shut-Off Valve first.
Remove Dust Cap by pulling straight up as shown
in Figure 1.
6

POSITION TOILET ON FLANGE

a. Unplug floor waste opening. Ensure supply hose is outside of toilet before installing, for outside toilet supply line. Install toilet on closet flange so
bolts project through mounting holes.
NOTE: To better view closet bolts when lowering toilet over flange, view through Seat Post Openings to align closet bolts through toilet mounting
holes while shinning a flashlight. (reference FIGURE A)
b. Place T-handle through hole opening of seat post about 3 inches and align with bolt. Carefully place plastic flange nut onto T-handle with your free
hand, then lower down over bolt of waste flange and loosely tighten. Repeat for opposite side. (reference FIGURE B)
SEAT POST OPENING
A
FIGURE 1
FIGURE A
4

INSTALL WAX SEAL

Invert toilet on floor (cushion to
prevent damage), and install wax
ring evenly around waste flange
(horn), with tapered end of ring
facing toilet.
DUST
CAP
- 2 -
TOILET WATER
SUPPLY CONNECTION
REGULATOR
Positioned for
outside of toilet
supply connection.
T-HANDLE
FIGURE B
7302429-10 0 Rev. 1 2 /2 0
WAX RING