eKey Home Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Шлюз eKey Home. eKey Home 20 сторінок.
Також для eKey Home: Інструкція з експлуатації Посібник з експлуатації (17 сторінок)
Друкувати сторінкуENGLISH
7.1.10
CHANGING THE RELAY SWITCHING TIMES
The switching impulse times of the individual relays can be variably adjusted from 1s to 99s. This enables you to
adjust the duration of the opening impulse of the door according to your application.
If the value 0 is assigned to a relay in this menu, then a special function is active. In this case the relay is bi-
stable. This means that when a finger is recognised, the relay changes to its switched state and remains there
until another finger is recognised. That relay thereby works as a switch and does not emit an impulse.
WARNING ! If there is a power cut in this operating mode, then the relay always restarts in idle state
once the power supply has been reconnected. NO contact = open !!
First enter the safety code as per section 7.1.5
7.1.10.1
ALTERING THE RELAY IMPULSE TIME
Keep pressing the > button until "rt" is displayed.
Press the OK button.
Use the < and > buttons to select "o1", "o2" or "o3" for the desired relay (NOT on ekey home and ekey
home integra systems, as they only have one relay available!)
Press the OK button.
Use the < and > buttons to set the desired duration of the switching impulse.
o
o
o
o
o
o
Press the OK button.
"OK" will appear on the display for a short time. The device then returns to normal mode.
The duration of the impulse has been defined for the selected relay.
7.1.11
RESETTING TO FACTORY SETTINGS
If you reset the device to its factory settings all data in the memory are deleted. The security code is reset to
the standard value of 99 and the control panel and the finger scanner are disconnected.
First of all enter the security code as per section 7.1.5
7.1.11.1
PERFORMING THE RESET
Press the > button until "rr" is displayed
Press the OK button
Enter the left digit of the security code using the < and > buttons (factory setting is 9)
Press the OK button
Enter the right digit of the security code using the < and > buttons (factory setting is 9)
Press the OK button
You will now see two red dots on the display. The orange light on the finger scanner is flashing. The device
is now in its delivered condition.
To start operating the device again, proceed from section Fehler! Verweisquelle konnte nicht
gefunden werden.
0 = Special function "switch"
1 = 1 second
2 = 2 seconds
.
.
99 = 99 seconds