Da-Lite Da-Lift 10M Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підйомні системи Da-Lite Da-Lift 10M. Da-Lite Da-Lift 10M 8 сторінок. Projector lift 220v
Також для Da-Lite Da-Lift 10M: Інструкція з експлуатації (8 сторінок)
Друкувати сторінкуElectrical Wiring - Models 10M, 15M
1.
Install electrical hook up that applies to your unit. Make sure to
review your Electrical Installation Checklist and wiring diagram
(see Figure 3) for 120-volt switch, 220/240-volt switch, or DRC
low voltage control.
NOTE: Da-Lift projector lift has been internally wired at
Da-Lite. External wiring is completed by installer conforming
to local and national codes. Be sure the wires are long
enough for the Da-Lift to go up and down.
120V Wiring Diagram
120V.
Plug-In For T. V .
Figure 3
This Switch Cannot
Be Used With L. V .C.
240 Volt Wiring Diagram
Da-lite offers two styles of 240-volt wall switches for standard operation.
Please see wiring diagram included in wall switch box included with screen.
4
Up Limit
Switch N.C.
Opens When
Operated
Black (Hot)
White (Common)
White (Common)
120V.
Black (Hot)
Operating Switch,
Switch Box, And
Plate Furnished With
Da-Lift. (SPDT With
Center Off)
Black (Down)
Up
Off
Down
Side View Of
Switch & Box
2. Test installation by carefully running Da-Lift "up" and "down"
several times. Be prepared to stop the Da-Lift. Duty cycle is three
(3) minutes ON and three (3) minutes OFF.
3. Make sure Da-Lift stops in the up direction flush with the ceiling.
Junction
Box
Black & Yellow
Red (Up)
AC Common
AC Hot
120V. AC 60Hz.
2.2 AMP. Max