EKHO RX1200 Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підсилювач EKHO RX1200. EKHO RX1200 6 сторінок.

Installation

Connecting Output

Make sure the amplifier is turned off before you wire the system. Speakers can be connected using speaker

NL4 plugs or bare wire for your binding post output connectors. Using the guidelines below select the

appropriate size of wire bases on the disctance between the amplifier and speaker.

Distance

Wire Size

<10m

1.5mm2

>10m <20m

2.5mm2

>20m <30m

4.0mm2

Setup operation mode

Amplfier can used in 2 modes:

1. Stereo operation

Set the mode selector (3) to the 'stereo' position.

In this mode the amplifier have two independed channels with there own inputs and volume controls.

2. Bridge operation

Set the mode selector (3) to the 'bridged' position.

This mode combines both amps on one channel which results in double power on this channel. Connects

the signal to the A input channel and the output level can now be adjusted with the A volume control.

Connect the speaker across the positive (+) output therminals. Do not use the negative (-) terminals when

the amplifier is being operated in bridged mode.

NOTE: Never connect a hot (+) output to ground or (-) output and never connect the hot (+) to other

hot outputs!

5 - 6