Ekinex EK-BK1-TP Посібник із швидкого старту
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Шлюз Ekinex EK-BK1-TP. Ekinex EK-BK1-TP 4 сторінки. Dmx knx tp
Друкувати сторінкуGateway DMX – KNX TP
Code: EK-BK1-TP
KNX device with gateway function (protocol conversion)
between a serial RS485 network (Master function) with
DMX protocol and a KNX TP network over a twisted
pair
communicaton
cable.
integration of DMX devices over a RS485 serial network
in a KNX-based automation system for homes and
buildings.
Description
The
DMX
ekinex®
EK-BK1-TP
apparecchio KNX modulare per montaggio a quadro. is
a KNX modular unit for panel mounting. It allows you to
exchange informations with one or more slave devices
over a RS485 differential serial network through DMX
protocol. The ekinex gateway acts as DMX master. The
informations exchanged over the DMX network are
updated over the KNX network by means of a twisted
pair (TP) communication cable.
The device manges a one-way data stream: up to 12
bytes of KNX data are defined, each one associated
with a device over the DMX network. The gateway
converts the data coming from KNX master and writes
its value on the corresponding DMX device.
Configuration is performed through a PC application
software which communicates through the integrated
Ethernet port. The application software CGEKBK1TP is
available for download at www.ekinex.com.
Data sheet STEKBK1TP_EN
V1.02 – 11 2015
Ideal
application
in
gateway
è
un
Pag. 1
Main features
DMX side
•
RS485
serial
communication
isolated from power supply, 120 Ω termination
resistance insertable by a 1-way microswitch
•
DMX master communication
•
Baud rate: 250 kbaud
•
Device addressing from 0 to 512
•
1-byte register writing on max 512 DMX devices
KNX side
•
KNX TP (Twisted Pair) communication port set to
9600 baud, electrically isolated from power supply
Ethernet port
•
Ethernet communication port (IEEE 802.3), RJ45
connector, minimum cable category: 5E.
Technical data
•
Power supply: 8...24 Vac or 12...35 Vdc. Power
Absorption at 24 Vdc: 3,5 VA.
•
Installation on 35 mm DIN rail (according to EN
60529)
•
Plastic case
•
Protection degree IP20 (according to EN 60529)
•
Safety class II
•
Weight 145 g
•
Modular device 4 UM (1 UM = 18 mm)
•
Dimensions 72 x 90 x 60 mm (WxHxD)
Environmental conditions
•
Operating temperature: - 40 ... + 85°C
•
Stock temperature: - 25 ... + 55°C
•
Transportation temperature: - 25 ... + 70°C
•
Relative humidity: 93% non-condensing
Display and command elements
The device is equipped with a pushbutton and a KNX
programming LED, with a status LED and terminal
blocks for KNX and RS485 network connection. A port
for RJ45 connector for device configuration via Ethernet
as well as two 1-way microswitches are also present.
port,
electrically