Dongcheng DJX03-255 Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пила. Dongcheng DJX03-255. Dongcheng DJX03-255 14 сторінок. Electric mitre saw
Друкувати сторінку
workpieces. Insert the rods of the holder assembly into the holes in the base and
tighten the screws to secure the holder assembly. (Fig. 19)
Cutting Operation
CAUTION:
Be sure to release the handle from the lowered position by pulling the stopper
pin before use.
Make sure the blade is not contacting the workpiece, etc. before turning on the
switch.
Do not apply excessive pressure on the handle when cutting. Too much force
may result in overload of the motor and/or decreased cutting efficiency.
Gently press down the handle to perform the cut. If the handle is pressed down
with force or if lateral force is applied, the blade will vibrate and leave a mark
(saw mark) in the workpiece and the precision of the cut will be impaired.
Press Cutting
CAUTION:
Part
of
the
workpiece,
the
thickness of which equal to the
thickness of the blade, will be cut off
when making cutting operations with
this tool. So position the cutting line
on the left or right side of the kerf
groove for precise cutting. (Fig. 20)
Secure the workpiece with the vise.
Switch on the tool without the blade
making any contact and wait until the blade attains full speed before lowering.
Then lower the handle slowly. When the blade contacts the workpiece, gently
lower the handle to begin the cutting operation.
-15-
When the cut is completed, switch off the tool and wait until the blade has come to a
complete stop before returning the blade to its fully elevated position.
Miter Cutting
Refer to the instructions of "Adjusting the Miter Angle".
Bevel Cutting
CAUTION:
Always set the sub-fence to the left position when performing left bevel cuts.
Always be sure that the blade will move down to bevel direction during a bevel cut.
Keep hands out of path of saw blade.
During a bevel cut, it may create a condition whereby the piece cut off will come to
rest against the side of the blade. If the blade is raised while the blade is still rotating,
this piece may be caught by the blade, causing fragments to be scattered which is
dangerous. The blade should be raised only after the blade has come to a complete
stop.
Apply pressure parallel to the blade when pressing the handle down. If the pressure is
not parallel to the blade during a cut, the angle of the blade might be shifted and the
precision of the cut will be impaired.
Refer to the instructions of "Adjusting the
Bevel Angle" to set the bevel angle.
Secure the workpiece with the vise. Switch
on the tool without the blade making any
contact and wait until the blade attains full
speed before lowering. Then lower the
handle slowly. When the blade contacts the
workpiece, gently lower the handle to begin
the cutting operation. (Fig. 21)
-16-