Astonica 50103303 Інструкція з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Внутрішнє оздоблення приміщень Astonica 50103303. Astonica 50103303 2 сторінки. Fallbrook bar stool

Друкувати сторінку
PARTS & HARDWARE LIST
PART #
Armrest
A
Seat
B
Seat Back
C
Footrest
D
Back Support
E
8mm Threaded Stud
F
8mm Flat Washer
G
H
8mm Hex Nut
8mm Cap Nut
I
J
6mm Threaded Stud
K
6mm Flat Washer
6mm Hex Nut
L
Adjustable Foot Pad
M
A
B
D
G
F
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-800-843-2446.
NOTE: This product is intended for residential, non-commercial use.
DESCRIPTION
C
E
L
I
J
K
H
1
QUANTITY
Figure 1
4
2
2
2
2
16
16
8
8
12
12
12
8
Attach Seat Back to Left Side of Chair
1. (SEE FIGURE 1) Install four threaded studs (F) into seat back (C).
2. Place the (seat back) threaded studs through armrests (A) mounting tabs. Attach each stud
using flat washer (G) and cap nut (I). Do not over tighten.
Attach Seat to Left Side of Chair
1. Screw four threaded studs (F) into the seat (B).
2. Place the (seat) threaded studs through the armrest (A) mounting tabs. Attach each stud
using flat washer (G) and hex nut (H). Do not over tighten.
Attach Back Support Bar, Footrest
M
1. Attach back support bar (E) to left armrest with threaded stud (J), flat washer (K) and
hex nut (L). Do not over tighten.
2. Attach footrest (D) to left armrest (A) with two threaded studs (J), flat washers (K) and
hex nuts (L). Do not over tighten.
Attach Left and Right Sides of Chair
1. Attach back support bar (E) and footrest (D) to the right armrest (A) with three threaded
studs (J), flat washers (K), and hex nuts (L).
2. Connect the seat (B) and back (C) with four threaded studs (F), flat washers (G),
and hex nuts (H) and cap nuts (I).
3. Stand the chair upright. Tighten all bolts.
4. Screw in and adjust the footpads (M) to level the chair.
ASSEMBLY INSTRUCTIONS
I
G
F
A
F
H
G
L
K
J
M
2
C
A
B
E
D