Donovan Sidewinder Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Запчастини для вантажівок Donovan Sidewinder. Donovan Sidewinder 16 сторінок. Electric side-flip tarp system

Друкувати сторінку

Hydraulics for Electric/Hydraulic Systems

NOTE: Skip to page 10 if using wet kit.

STEP 1: Using pump mount bracket as template, locate and

mark where hydraulic unit will mount - approximately 1' below

actuator unit.

NOTE: Included hydraulic hoses are roughly 3' long.

STEP 2: Remove pump mount bracket and drill 13/32" holes in

marked locations.

STEP 3: Install pump mount bracket using 3/8" bolts

ers

and lock nuts

MOUNTING BRACKET

STEP 4: Install two rubber bumpers to pump mounts bent tabs

and mount pump itself using included 3/8" studs, lock nuts

and washers

PUMP

STEP 5: Secure bottom of reservoir to mount bracket with in-

cluded 5-7" adjustable hose clamp.

DONOVAN

RUBBER

BUMPERS

HELP LINE: 1-800-327-8287

STEP 6: Connect two hydraulic hoses between pump and cyl-

inder. Port C2 to cap end of cylinder and Port C1 to rod end of

cylinder. Use hose clips and self-drilling screws

and secure hoses to trailer.

Item Part #

1. 1800925 Elbow 90º - #4 JIC M x #6 ORB M

2. 1800112 Elbow 90º - #4 JIC M x 1/4" NPT M

3. 1801235 Hydraulic Hose - 37-1/2" OAL

4. 1800850 Hydraulic Pump - 12V

5. 1800205 Hydraulic Cylinder - 15-1/2" Stroke

CAP END

, wash-

STEP 7: Mount control switch using two self-drilling screws

Connect control switch to pump solenoid wiring harness. Se-

cure quick disconnect power cable near control switch. Use

hose clips and self-drilling screws

cables to trailer.

CONTROL

SWITCH

CABLE MUST

EXIT AT BOTTOM

STEP 8: Install all provided safety stickers next to control switch.

Stickers detailed on page 11.

STEP 9: Remove red cap from filler neck on reservoir and fill

with approximately three quarts (2.83 Liters) of Dextron Auto-

matic Transmission fluid. Replace red cap with black breather

cap.

NOTE: Under normal operating conditions fluid will last

life of pump. In extreme dirty or wet conditions, check fluid

every four to six months and change as needed.

STEP 10: Connect a 12V power supply to quick disconnect

power cable and cycle cylinder ten times to remove any air in

system. Failure to do this may result in personal injury and/or

damage to Sidewinder™ system.

P/N 1809453 Rev. A

Description

to organize and secure

to organize

ROD END