Dontek PWP2 Ioniser Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Системи фільтрації води Dontek PWP2 Ioniser. Dontek PWP2 Ioniser 7 сторінок.

Друкувати сторінку

OPERATING INSTRUCTIONS

CONTROLLER INFORMATION

The pool water purifier PWP2 is suitable

for swimming pools, spas and ponds up-

to 100,000 litres for a standard unit.

The

filter

pump

controlled for up-to 2 run times per day

and

will

remember

indefinitely and the clock will remain

accurate if the power is switched off for a

period of up-to 10 days. The PWP2 can

be used on interrupted power supplies

(e.g. tariff 33 in QLD).

The ions active L.E.D. indicates that the

ionisation process is working. The polarity

L.E.D.'s indicate the polarity of the output

current applied to the electrodes, the

polarity will change every 15 minutes to

allow the electrodes to wear evenly.

PWP2_Instructions_rA1.docx

and

ionisation

the

settings

WATER BALANCE

On new pools the conductivity of the

water can be low so it may take some

weeks to obtain a copper reading. As the

copper level increases the conductivity

will also increase and the copper level will

start to rise faster. It is fine to start on

250mA but you will need to monitor the

copper levels every couple of weeks and

when the level has started to rise towards

0.4ppm start reducing the Ions Output.

Copper levels can climb quicker with salt

pools as the conductivity of the water is

higher. Filter run time and Ions Output

can both be used to achieve correct

copper levels. If the copper level in the

water exceeds 0.6ppm turn the Ions

Output to Zero. Water balance should be

checked at least weekly during the

swimming season and monthly over the

winter period.

Total Alkalinity 100 - 150 ppm

Water pH 7.4 - 7.8

Copper 0.4 – 0.5 ppm

Chlorine – 1.0ppm Plus

Water balance should be checked at least

weekly during the swimming season and

monthly over the winter period. Without

regular checking of the water balance and

the addition of pool chemicals, copper

may become unsettled and can plate out

of solution, causing staining on the

swimming

manufacturer and the dealer of the PWP-

2 bares no responsibility for such staining

pool

responsibility of the pool owner/s.

pool

surface

water

chemistry

–

the