Astor-Bannerman ABW6SP Посібник користувача та інструкція з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача та інструкція з монтажу для Сантехнічний виріб Astor-Bannerman ABW6SP. Astor-Bannerman ABW6SP 12 сторінок. Height adjustable basin
Друкувати сторінкуManual operation of the lever tap system
In normal operation the levers should be facing forward, (towards the user) when off. To operate
them, rotate the levers outwards to achieve the flow-rate required. To stop water flowing, rotate the
levers until they are facing forward once again.
The waste plug
To the rear of the tap block is a small rod with a 'knob' fitted to the top. This can be raised and
lowered to open or close the waste plug as required.
Operating the touch tap system
The taps are usually set as wave ON-Wave OFF.
To turn the water ON /OFF pass your hand above the Sensor on the basin top.
Caution: The unit is fitted with a safety mechanism, if the unit encounters an obstruction
under the front portion of the basin whilst travelling downwards it will automatically stop.
Pressing the 'Up' button will allow the obstruction to be removed. Care should be taken
to ensure that whilst the basin assembly is moving downwards there are no obstructions
left directly beneath the basin or rise & fall unit as the safety mechanism is designed to stop the unit
only when the front of the basin is lifted.
If both the 'Up' and Down' buttons are pressed at the same time the unit will not move.
Cleaning
The basin and vanity top may be cleaned using most mild cleaning agents. Chemical agents must
not be used, i.e., drain cleaners, acetone, oven cleaners or acids. The rise and fall unit, mirror and
handset should be cleaned using a warm soapy solution and rinsed with a damp cloth. Attention
should always be paid to instruction labels on the outside of cleaning agent containers.
Page: 3
Touch Tap
Sensors
in position
Version : 11-04-016