DAB ACTIVE DRIVER T/T 3.0 Посібник з програмування - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з програмування для Контролер DAB ACTIVE DRIVER T/T 3.0. DAB ACTIVE DRIVER T/T 3.0 10 сторінок.

Programming > Pump Start Up

Once you have installed the ACTIVE DRIVER and the pump is primed and ready to start, these

are the simple steps to programming the controller.

After switching the power supply on, the following indication should be present,

= Zero Flow & General Reset

Shortly after, the ACTIVE DRIVER should switch to the following condition and the pump

should start.

= Pump Operating

It should then stop after demand has ceased and now display,

= Pump Waiting (Standby)

The pump is now idle and waiting for demand pressure to drop in order to start.

Programming > Inputting Data

The ACTIVE DRIVER is pre programmed and will operate the pump with out any additional

programming, but for most efficient operation, settable parameters are offered to optimal

performance of the system.

The AD M/T and AD T/T will need information about the pump to be inputted before safe

operation can begin.

The settable parameters are as follows,

SP >SET POINT

To access this setting, press [mode] and [set] simultaneously for two seconds, the

display should indicate

This can be changed in Bar from a minimum setting of 1.0 up to 6.0 in the AD M/M 1.1,

and 9.0 in all other models. Using the [+] or [-] keys will lift or lower the setting.

Once the setting has been made, pressing [set] will return the indication to the

operating mode of the system (Go or Sb)

rC >RATED CURRENT

applicable to AD M/M 1.1).

To access this setting, press [mode], [set] and [-] simultaneously for five seconds, the

display should indicate

be changed to reflect the correct current of the pump being used. (Check compliance

plate or call 1300783601 if unsure). Inputting the wrong information here can damage

the pump. This setting will not appear when programming the AD M/M 1.1.

Once the setting has been made, pressing the [mode] key will move the display to the

next settable parameter, pressing [set] will return the indication to the operating mode

of the system (Go or Sb)

, is the desired operating pressure of the system.

, and then flash to

, is specific to the pump being used (not

0.0

, and then flash to

3.0

which is the pre set of 3.0 Bar.

which is the pre set. This should