DoorHan PCB-SH Інструкція з програмування - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з програмування для Відкривач воріт DoorHan PCB-SH. DoorHan PCB-SH 16 сторінок. Control board
Також для DoorHan PCB-SH: Інструкція з програмування (14 сторінок), Інструкція з програмування (12 сторінок)
Друкувати сторінку
1.2. CONTROL UNIT TERMINALS DESCRIPTION
Type
Color
Jack
ХP9
ХP7
ХP3
ХP8
ХP6
ХP2
ХP1
Terminals
№
Meaning
Full opening command. After closing of contacts of the device connected
1
Open
to this terminal, the control unit will trigger either full opening of the door or
stepped control of operator (depending on the preset control logic)
Close command. After closing of contacts of the device connected to this
2
Close
terminal, the control unit will trigger door closing
3
Com
Common contact
Stop command. After breaking of contacts of the device connected to this
1
STOP
terminal, the control unit will stop door movement
Contacts for safety device connection (NC). Safety devices are used to
prevent people, animals and foreign objects from being jammed in the door
2
PH CL
opening by the moving door leaf. Activation of safety devices immediately
stops or reverses the door. If sensors of the safety devices responded when
the door was open, that will prevent any movement of the door
3
COM
Common contact
Terminal for connecting of end switch which is responsible for extreme
1
SW CL
position to closing on cloth (red wire from end switch)
Terminal for connecting of end switch which is responsible for extreme
2
SW OP
position to opening on cloth (green wire from end switch)
3
COM
Common contact (white wire from end switch)
1
(–)
For accessories power supply
2
+24
1
Terminals for connecting of signaling lamp ~ 220 V. This split is only
LAMP
present on board of version 1.1
2
1
N
common terminal of electromotor
2
L1
terminal on closing of electromotor
3
L2
terminal on opening of electromotor
1
N
connecting of mains supply ~ 220 V
2
L
CONTROL UNIT DIAGRAM
Connecting devices
9