DoorHan SECTIONAL-800PRO-CE Посібник з монтажу та експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Відкривач воріт DoorHan SECTIONAL-800PRO-CE. DoorHan SECTIONAL-800PRO-CE 20 сторінок.
Друкувати сторінку
6.3. BASIC PROGRAMMING
Menu
Function description
1
Door upper position
2
Door lower position
3
Automatic force adjustment
4
Partial opening of the door (ventilation): «Y» – on, «n» – off
5
Safety devices: «Y» – on, «n» – off
6
Reverse of the carriage when the door is closed
7
Automatic door closing: «0» – off, «1» – 30 sec, «2» – 60 sec, ... «8» – 240 sec
8
Reset to factory settings
9
Software version
1. Door upper position
Press and hold the button
«1» will light
«P» for about 5 sec
The setting will be stored only when you program the UPPER door position. The upper position shall be programmed before
setting the lower door position.
NOTE: If the chosen reference point is «stopper» (see p. 6.4.) than you should install the stopper on the guide rail so that it
fixes the upper position of the door.
2. Door lower position
Нажмите «+»
Press «+»
«2» will light
The setting will be stored only when you program the LOWER door position.
NOTE: If the chosen reference point is «micro switch» (see p. 6.4.) and the program does not exit the setting menu after the
door has been closed, the microswitch reference point must be checked.
3. Automatic force adjustment
Press «P», «3» will flash
Press «+», «3» will light
After finishing the automatic force adjustment, a beep will sound, and the program will exit the programming mode automatically.
After performing these setups, the programming can be finished; all other parameters have factory settings.
Press «P», «1» will flash
Pressing «+» and «-» set the door panel into upper position
required
замигает
Нажимая «–» и «+», установите полотно ворот в закрытое
Press «P», «2» will flash
Pressing «+» and «-» set the door panel into closed position
положени е
The door moves up to the upper stopper, then it performs full openning / closing cycle (the door moves three times: up, down, up)
OPERATOR PROGRAMMING
Press «P» to save
the information
Нажмите «Р» для
Press «P» to save
сохранения информации
the information
Default
–
–
3
n
n
0
0
r
1.хх
11