DoorHan SHAFT-120 Посібник з монтажу та експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Відкривач воріт DoorHan SHAFT-120. DoorHan SHAFT-120 12 сторінок.
Також для DoorHan SHAFT-120: Посібник з монтажу та експлуатації (12 сторінок)

Друкувати сторінку

6. Operator components

1.
Release cord
2.
Manual chain
3.
Reducer housing
4.
End switches

7. Installation

Before installation make sure that the gate is in good working condition and the torsion springs balance its leaf. Install the operator as
described below (Section "On-shaft mounting" or "Mounting via chain drive").

7.1 On-shaft mounting

Mount the mounting bracket on the wall using screws. The mounting bracket can be placed from the left or from the right of the
operator.
Turn the release knob by 180 degrees counterclockwise.
Mount the first closing ring on the gate shaft.
Mount the operator on the gate shaft (be sure, that the bushing key is in its proper position) and screw it to the mounting basis.
Mount the second closing ring on the gate shaft and push it close to the operator.
Mount the first closing ring close to the operator and fix both closing rings.
Closing ring
5.
Motor
6.
Control unit
7.
Manual drive unit
Bushing key Electric operator
Fastening bolt
OP ERATOR SH A F T -1 20 INSTAL LAT IO N AND OP E RAT ING MANU AL
Closing ring
Fastening bracket
Bolt (M10)
COMPONENTS
Shaft
5