DoorHan SLIDING-800 Посібник з монтажу та експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Відкривач гаражних дверей DoorHan SLIDING-800. DoorHan SLIDING-800 12 сторінок.
5. RELEASE MECHANISM OPERATION
Use the lever of embedded release mechanism to release the drive. When re-
leased, the door may be opened and closed manually.
If it's necessary to open the door manually when power is off or drive fails, use
the release mechanism:
1. Insert the key into the lock (Fig. 1).
2. Turn the key clockwise.
3. Without taking the key out, pull the lever of the release mechanism (Fig. 2).
4. Turn the key counterclockwise and remove the key from the lock.
5. Move the door manually.
Back to normal operation of system
To prevent from automatic push upon the door activation, power off the system
before locking the drive.
1. Insert the key into the lock.
2. Turn the key counterclockwise.
3. Without taking the key out, push the lever of the release mechanism against
stop.
4. Turn the key clockwise and remove the key from the lock.
5. Move the door manually until the drive is locked.
6. MAINTENANCE
Sliding-300/800 automatic system does not require any special maintenance.
•
Only qualified specialists trained in DoorHan authorized centre can carry out repair and maintenance.
•
The installer shall present the user how to unlock the door in case of emergency and deliver information on maintenance
and operation of the automatic system after its installation.
•
Use DoorHan original spare parts during maintenance.
•
Check DoorHan automatic system for problems at least once per 6 months.
•
Check the smooth movement of the door under automatic control regularly.
•
Check the correct installation of extreme positions, operation of safety devices regularly.
•
When power is off, the door stops. After power is on, the drive can be controlled under normal mode.
•
Deliver the product to a special recycling center upon expiration of its service life!
•
If you lose this manual, you can request a duplicate by sending a letter to: Kralovsky VRCH 2018, Kadan, 43201, Czech
Republic or e-mail to: [email protected].
•
The manufacturer (DoorHan) does not exercise direct control over the door and automatic equipment installation, their
maintenance and operation and can not be responsible for the safety of the door and automatic equipment installation,
operation and maintenance.
7. TROUBLESHOOTING
Malfunction
Drive does not operate
The door does not move after use of
release mechanism
Drive stops suddenly
The door does not open or close to the full
Potential reason
Disabled power or absence of power
Obstacle in door movement
Bad wiring connections
Drive is in ungeared position
Drive thermal protection is activated
Improper adjustment of limit switches or operating
time
Improper adjustment of limit switches
Force protection is activated
RELEASE MECHANISM OPERATION
Remedy
Make sure of power
Remove the obstacle
Check the wiring connections
Put the drive in gear
Let the drive cool
Adjust the position of limit switches and adjust the
operating time
Adjust the limit switches
Adjust the drive force
1
2
9