DAC RA711-GSM Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Телефон DAC RA711-GSM. DAC RA711-GSM 12 сторінок.

Commands

USERTEXT message

The telephone compiles and sends an SMS text message [USERTEXT] to a command origina-

tor, to confirm changes of configuration after an incoming command has been processed, or to

a maximum of three (3) SMS destinations as asynchronous responses to changes in telephone

status. This essentially means that when the USER [command originator] changes a program-

mable parameter within the telephone via SMS, the telephone will respond to the USER via SMS

confirming the changes. In addition to this the telephone will also respond to up to three (3) other

numbers notifying that a change has been made. A human readable format is used as follows:

Location: {location of telephone} this can be configured via SMS

Type: <Status_text> This indicates parameter that has been changed or modified.

Battery: [Battery_voltage] current battery voltage e.g. 11.95V accurate to approx. 37mV

Signal: [GSM Signal_level] Range is 0-31 (0 unregistered, 31 max strength)

Last Call: [Duration of last call if over 10 seconds]

Ver: <Firmware _Version> Factory preset.

Configure or change USERTEXT recipients [CTX]

In order to configure the USERTEXT recipients [person (s) who receives notification of parame-

ter change or system error] the telephone will require data input via SMS using the CTX

command. Up to 3 numbers can be stored [3 recipients] and the numbers are input as follows:

CTX1234....+441234567890.+442345678901.+449876543210

It is important that these 'full stops' are added (and correct PIN if changed)

The originator [the person who sent the SMS command] and the USER LIST will receive the

following message indicating that a parameter has been modified:

Location: {location of telephone} this can be configured via SMS

Type:

New SMS No's set

Battery: [Battery_voltage] current battery voltage e.g. 11.95V accurate to approx. 37mV

Signal: [GSM Signal_level] Range is 0-31 (0 unregistered, 31 max strength)

Last Call: [Duration of last call if over 10 seconds]

Ver: <Firmware _Version> Factory preset.