Doortec DOORMAN SDO1 Посібник з встановлення та експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Система відкривання дверей Doortec DOORMAN SDO1. Doortec DOORMAN SDO1 8 сторінок.
Друкувати сторінку6.Programming the Operator
6.1
Keep trolley locked, pull and/or push the door by hand, make
6.1.1
sure the trolley connects with the traveller.
Turn on the power, the courtesy light is on for several seconds,
the LED displays the numbers from " 9 " to " 1 ".
6.1.2
The operator turns to standby mode.
After the units "self-testing" it displays " II " or " - ".
6.1.3
6.2
Press and hold SET until the unit displays " 1 ".
6.2.1
Press and hold UP, for opening limit, the door will start to
6.2.2
run
When the door has reached the open position, press SET
6.2.3
to confirm setting. The unit displays " 2 ".
Press and hold DOWN, for close limit. When the door has
6.2.4
reached the closed position, press SET to confirm setting.
The door will now open and close automatically to map
6.2.5
the open and close sensitivity force requirements.
The unit displays " II " to show the setting is complete.
6.2.6
6.3
When the unit has stored 20 codes, it will flash " F ", This
6.3.1
indicates that the receiver has reached its limit and is full
6.3.2
Press and hold CODE, until it displays "
Hold for more than 8 seconds, until the unit flashes " C `" ,
6.3.3
all remotes are now deleted.
6.4
6.4.1
Press and release CODE, the unit displays
Press a button on the transmitter, then release and press
6.4.2
the same button again, "
The unit displays " II " to show setting is complete. Repeat
above steps to code a maximum of 20 different
6.4.3
transmitters.
Preparation
Setting Open and Close Limits
Self Learning Transmitter
Adding or Changing Transmitters
" flashes,
".
"
5
.
".