Astralpool 25392 Посібник з монтажу та обслуговування - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу та обслуговування для Освітлення басейну Astralpool 25392. Astralpool 25392 10 сторінок. Underwater projector for fibre optics
Друкувати сторінку
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety
measures to be implemented for installation and start-up. Therefore, the installer as well as the user
must read the instructions before beginning installation
In order to achieve optimum performance of the Underwater light, we recommend that you follow the
instructions below:
1. CHECK THE PACKAGING:
Inside the box, you will find the following components.
Underwater light 25391 - 25392:
· Projector body
· Flat lens
Projector 25391: . 2 adhesive joints
2. GENERAL CHARACTERISTICS:
Projectors for concrete swimming pools, manufactured in plastic and designed for use both outdoors and
totally submerged in fresh water swimming pools.
The concave lens provides a larger light beam opening angle than the flat lens.
3. INSTALLATION:
In ordr to prevent glare, the floodlamps should be installed so that they face away from
residence or usual view of the swimming pool.
In the event that lighting is used in training or competition pools, the floodlamps should be
installed on the sides to prevent glare on the swimmers.
The projectors should be placed on the wall of the pool at about 200-300 mm. under the water
level
Whatever the assembly method used, ensure that the unit is properly sealed to avoid water from entering
the projector
4. ASSEMBLY:
Assembly projector 25391
To place the projector 25391 in a prefabricated swimming pool, a 65 mm. diameter circular hole should be
made in the swimming pool panel. Place the body of the projector with the two flat joints and on the
outside of the pool, fasten it using the bearing nut. Place one of the adhesive joints on the projector body
and the other in the flange. (Fig. 1)
Once the liner has been installed, fasten the flange to the projector body using the 6 screws
Din 7985 A2 M-5×14.
Assembly projector 25392
To place the projector 25392 in a prefabricated swimming pool, a 65 mm. diameter circular hole should be
made in the swimming pool panel. Place the body of the projector with the two flat joints and on the
outside of the pool, fasten it using the bearing nut. (Fig. 2)
Once the body of the projector has been assembled, insert the cable with the centering device (not
supplied) and place the lens with the O-ring using the spanner code 18413 according to figures 3 and 4.
5. SAFETY WARNINGS:
⋅ The persons who are in charge of assembly should have the required qualifications for
this type of work
⋅ Comply with the current standards regarding accident prevention.
⋅ The manufacturer is not responsible in any circumstances for assembly, installation
or start-up of any electric components which have been inserted or handled at
locations other than its own premises.
· Nut
. Trim cover
· Concave lens
. Lens O-ring
. DIN 7985 M5x14 Screw 6
· Flat joint
(2 units – 25392)
. Housing clamp