Canon DM-MV310E Посібник - Сторінка 28

Переглянути онлайн або завантажити pdf Посібник для Відеокамера. Canon DM-MV310E. Canon DM-MV310E 32 сторінки.

Друкувати сторінку

1. System Chart

DM-MV300E/MV300iE/MV310E

CHAPTER 1. GENERAL DESCRIPTION OF PRODUCT

7-4 Battery status (Remaining battery, Warning indications, shut off by insufficient power)

Battery status

•

When using the unit on a battery, the battery status is indicated in five steps, i.e. 100%, 75%, 50%, 25% and 0% (approximate

values) until the insufficient-power warning appears, then is reset by switching the power off. When the unit is off and on again,

the battery regains its power (the battery status indication shows higher) sometimes. However, once the battery low warning

appears, the Low battery warning is displayed even when the power is regained by turning the unit off and on.

•

The battery status indication is off when using the unit on the AC power adapter. However, when the power level decreases,

because of some malfunction (dropping below the battery low level), the battery low warning will go on. Then, should the power

increase above the battery low level, the battery low warning will disappear.

•

Battery low warning appears when the voltage across the battery connectors falls below approx. 6.3V (when using with this product)

7-5 System data indication

Data Code (Date&Time)

Data Code (camera data)

Time Code

Audio Mode (12/16bit)

WIDE/Normal

CGMS (warning)

SP/LP

* IF there is no tape, the Time Code is shown as "—:—:—:—" in the unrecorded portion.

* CGMS : When copying is prohibited, the LINE OUT, CVF (panel) do not appear.

7-6 Data code indication

It is possible to independently set the Data Code indications on/off (regardless the other on-screen character indications).

7-7 MP tape

MP tape cannot be recorded in the LP mode. Even with the LP mode selected in the Menu, the tape will be set to the SP mode forcibly.

Playback of LP-recorded tape is made in LP mode.

7-8 Warning buzzer

Warning buzzer is activated in the following cases :

Turning the power on

Insertion of a cassette with the erasure prevention tap set to SAVE (camera mode) pip-pip-pip

EJECT cover fully open (also in when power is off)

Recording start (camera mode)

Recording pause activation (camera mode)

Halfway pressed photo button ; OK status

Mode transition (VCR mode)

Photo recording start

Dew condensation, mechanism error, and 5 seconds before going off with

the 5-minute timer in the recording pause (*) mode

Setting button operation of an item which cannot be selected in the menu

20, 15, 10 seconds before going off with the 5-minute timer in the recording pause (*) mode beep-beep-beep

Self timer (simultaneous tally flashing)

Including recording pause (*) in the audio dubbing, AV insert modes.

*Frequency of the "pip" tone is 4 kHz, of the "beep" tone is 2 kHz, of the "buuh" tone is 1 kHz.

Camera Mode

Camera Picture

Rec Search

× (Appears in LANC) × (Appears in LANC) ×— — —

K 4 sec. indication ×

K Setting indication ×

K Setting indication K

Mode

1-30

VCR Mode

DIF Input

Blue Back

×— — —

× F— — —etc.

×F— — —etc.

K Main unit

K DIF side

K Setting indication K Setting indication K

Sound

pip

pippip

pip

pippip

pip

beep (a simple tone) ×5 times

buuh

pippip ×8 times (every second)

pip ×8 times (every 0.25 second)

PB (incl. special playback)