AMES Colt C200 Встановлення, обслуговування та ремонт

Переглянути онлайн або завантажити pdf Встановлення, обслуговування та ремонт для Блок управління AMES Colt C200. AMES Colt C200 4 сторінки. Double check valve/detector assemblies

Друкувати сторінку

Installation, Maintenance, & Repair

Colt

Series C200, C300, LFC300

™

Double Check Valve Assemblies

Double Check Detector Assemblies

Sizes: 2

⁄

" – 10" (65 – 250mm)**

WA R N I N G

Read this Manual BEFORE using this equipment.

Failure to read and follow all safety and use information

can result in death, serious personal injury, property

damage, or damage to the equipment.

Keep this Manual for future reference.

WA R N I N G

You are required to consult the local building and plumbing

codes prior to installation. If the information in this manual

is not consistent with local building or plumbing codes,

the local codes should be followed. Inquire with governing

authorities for additional local requirements.

WA R N I N G

Need for Periodic Inspection/Maintenance: This product must

be tested periodically in compliance with local codes, but at least

once per year or more as service conditions warrant. If installed on

a fire suppression system, all mechanical checks, such as alarms

and backflow preventers, should be flow tested and inspected in

accordance with NFPA 13 and/or NFPA 25. All products must be

retested once maintenance has been performed. Corrosive water

conditions, and/or unauthorized adjustments or repair could render

the product ineffective for the service intended. Regular checking

and cleaning of the product's internal components helps assure

maximum life and proper product function.

Testing

For field testing procedure, refer to Ames installation sheets

IS-A-ATG-1 found on www.amesfirewater.com.

For other repair kits and service parts, refer to our Backflow

Prevention Products Repair Kits & Service Parts price list

PL-A-RP-BPD found on www.amesfirewater.com.

For technical assistance, contact your local Ames representative.

NOTICE

Inquire with governing authorities for local installation

requirements

NOTICE

For Australia and New Zealand, line strainers should be installed

between the upstream shutoff valve and the inlet of the backflow

preventer.

It's important that this device be tested periodically in

compliance with local codes, but at least once per year or more

as service conditions warrant. If installed on a fire sprinkler

system, all mechanical checks, such as alarm checks and

backflow preventers, should be flow tested and inspected

internally in accordance with NFPA 13 and NFPA 25.

NOTICE

Due to shipping, storage, and general handling, the Victaulic

Coupling for the shutoff valves may have loosened and should be

retightened during installation.

RP/IS-A-C200/C300

C200 OSY