Cognex DataMan 475 Короткий довідник - Сторінка 10

Переглянути онлайн або завантажити pdf Короткий довідник для Промислове обладнання Cognex DataMan 475. Cognex DataMan 475 18 сторінок. Verifier

Connect the Breakout Cable

CAUTION:

To reduce emissions, connect the far end of the Breakout cable

shield to frame ground.

Note:

I/O wiring or adjustments to I/O devices should be performed when

the verifier is not receiving power.

You can clip unused wires short or use a tie made of non-conductive

material to tie them back.Keep bare wires separated from the +24

VDC wire.

1. Verify that the 24 VDC power supply is unplugged and not receiving power.

2. Attach the Breakout cable's +24 VDC and Ground to the corresponding

terminals on the power supply.

CAUTION:

observe the polarity shown.

3. Attach the Breakout cable's M12 connector to the DataMan 475 verifier's 24

VDC connector.

4. Restore power to the 24 VDC power supply and turn it on if necessary.

Never connect voltages other than 24 VDC. Always