Dopo D9018 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Планшет Dopo D9018. Dopo D9018 9 сторінок.

Друкувати сторінку

FCC STATEMENT

1.This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including

interference that may cause undesired operation.

2.Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate

the equipment.

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment dose cause harmful

interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

The radiated output power of this device is below the

FCC radio frequency exposure limits. Nevertheless, the

device should be used in such a manner that the potential

for human contact is minimized during normal operation.

The exposure standard for wireless devices employs a

unit of measurement known as the Specific Absorption

Rate, or SAR. The SAR limit set by the FCC is 1.6

W/Kg.

Tests for SAR are conducted using standard operating

positions accepted by the FCC with the device

transmitting at its highest certified power level in all

tested frequency bands. Although the SAR is determined

at the highest certified power level, the actual SAR level

of the device while operating can be well below the

maximum value. This is because the device is designed

to operate at multiple power levels so as to use only the

power required to reach the network. In general, the

closer you are to a wireless base station antenna, the

lower the power output. To avoid the possibility of

exceeding the FCC radio frequency exposure limits,

human proximity to the antenna should be minimized.