Acer AcerPower SP Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Робочий стіл Acer AcerPower SP. Acer AcerPower SP 21 сторінка. Acer acerpower sp: users manual

Друкувати сторінку

4. Troubleshooting

The following questions are possible situations that may arise during the use of

your computer and each is followed by simple answers and solutions to the

situation.

Q: I pressed the power switch but the system did not boot up.

A: Check the LED located above the power switch.

If the LED is not lit, no power is being applied to the system. Do any of the

following:

• Check if the voltage selector switch located on the rear panel of the

computer is set to the correct voltage.

• Check if you properly plugged the power cable into an electrical outlet.

• If you are using a power strip or AVR, make sure that it is plugged in and

turned on.

If the LED is lit, check the following:

• Is a non bootable (non system) diskette in the floppy drive? If yes, remove

or replace it with a system diskette and press Ctrl + Alt + Del to restart

your computer.

• The operating system files may be damaged or missing. Insert the startup

disk you created during Windows setup into the floppy drive and press Ctrl

+ Alt + Del to restart your computer. This will automatically diagnose your

system and make necessary fixes. However, if the diagnostic utility still

reports a problem, then you may have to perform the recovery process to

restore your system to its original factory default settings.

Q: Nothing appears on the screen.

A: Your computer's power management function automatically blanks the

screen to save power. Press any key to turn the display back on.

If pressing a key does not work, your computer. If restarting your computer does

not work, contact your dealer or the technical support center for assistance.