Astria Fireplaces MontebelloSTTYN Додаткові інструкції - Сторінка 2

Переглянути онлайн або завантажити pdf Додаткові інструкції для Внутрішній камін Astria Fireplaces MontebelloSTTYN. Astria Fireplaces MontebelloSTTYN 2 сторінки. Glass door assembly removal

Друкувати сторінку

INNOVATIVE HEARTH PRODUCTS • MONTEBELLO

INSTALLING GLASS DOOR, BARRIER,

AND MODESTY PANEL

See WARNINGS and CAUTIONS on other side.

NOTICE: Only doors certified with the appliance shall be used.

AVIS : Seules des portes certifiées pour cet appareil doivent

être utilisées.

Note: These instructions do NOT apply to the outer glass door

provided in the Outdoor Kit for indoor/outdoor installations of

Montebello See-Through models.

1) Install glass door, as follows:

a) Retrieve the glass door. Visually inspect the gasket on the back of

the frame. Gasket surface must be clean, free of irregularities, and

seated firmly.

b) Position the door in front of the firebox opening, with the top of the

door held away from the fireplace (see Figure 1 on other side).

c) Lower the bottom of the door assembly onto the bottom door track,

engaging and centering it in the base channel, and then gently swing

the door up.

d) Using a #3 Phillips screwdriver, fasten the door frame to the door

latches with the two (2) latch screws. The latches should pull forward

to engage the door frame.

f i r e - p a r t s . c o m

Note: Securely tighten latch screws when reinstalling glass door

assembly.

IHP reserves the right to make changes at any time, without notice, in design, materials,

specifications, prices and also to discontinue colors, styles and products. Consult your local

distributor for fireplace code information.

P/N 900345-01 Rev. A 05/2018

DIRECT-VENT GAS FIREPLACES • DOOR REMOVAL/INSTALLATION INSTRUCTIONS

2) Install the modesty panel on the top flange of the glass door, as follows:

a) Grasp the modesty panel with both hands (with the open hem facing

down).

b) Engage it with the upper lip of the glass door frame by pushing it

all the way down. Make sure the installed modesty panel is firmly

in place.

3) Install the barrier, as follows:

a) Slide the barrier, flat side toward the fireplace, into the right barrier

with gap below and drop down. Pull top to the face of the fireplace.

Lift the barrier up into the brackets.

b) Reinsert the lower filler piece by sliding the tab behind the barrier.

c) Center the barrier between the left and right barrier brackets and

lower the barrier until the lower filler piece and barrier lock into slot

openings in the bottom of the unit frame.

1769 East Lawrence Street • Russellville, AL 35654

IHP.US.com