Doran 2200 Series Посібник оператора - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник оператора для Сенсорна панель Doran 2200 Series. Doran 2200 Series 15 сторінок.

Password Protected Setpoint and Preact Values

If the password protection is activated, the display will display pass when the SET

POINT button is pressed. Enter the password and press ENTER. Press SET POINT to

change or review setpoints or press and hold SET POINT to edit or review preacts.

After reviewing the setpoints or preacts, the password will be required the next time the

SET POINT button is pressed.

Press SET POINT to display the current setpoint values. The last viewed or edited

setpoint will be displayed. Press UNITS and PRINT to scroll through the eight available

setpoints. The annunciators below the main display indicate the current setpoint. Press

SET POINT to exit this mode. The display will read abort to indicate no changes were

made to the setpoint values.

Press ZERO to momentarily display the current parameter settings and output logic for

that individual setpoint.

Press SET POINT to enter the setpoint edit mode. The last viewed or edited setpoint

will be displayed. Press UNITS and PRINT to scroll through the eight available

setpoints. The annunciators below the main display indicate the current setpoint.

To change the setpoint value, enter the setpoint value using the numeric keypad. Press

ENTER to accept the change and return to the weigh mode or press UNITS or PRINT to

save and edit other setpoints. Press SET POINT to exit this mode.

The display will read abort to indicate no changes were made to the setpoint values or

the display will read Saved to indicate the setpoint value is saved.

Press SET POINT to enter the Setpoint edit mode. The display will momentarily show

SEtPt, then flash the current setpoint weight. Press UNITS or PRINT to scroll to the

desired setpoint number. The annunciators below the main display indicate which

setpoint is currently displayed.

Using Doran's optional barcode scanner, scan the desired barcode. The display will

read SAVEd to indicate the scanned setpoint weight is saved. The display will flash the

new setpoint weight scanned from the barcode. No special serial commands are needed

prior to the weight data in barcode value. The barcode value must not exceed the

indicator's count by resolution and can not be greater than the capacity. The barcode

value can be read into each of the eight available setpoints. To exit the edit mode press

the SET POINT button.