ASTRO-MED Dash 10 Посібник із швидкого старту - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Вимірювальні прилади ASTRO-MED Dash 10. ASTRO-MED Dash 10 14 сторінок.
Друкувати сторінку
CHANGE GRID
• Press the soft key above either "CHART 1", "CHART 2", "CHART 3" or
"CHART 4". For a ten-channel configuration these are the layouts:
Astro 1 - provides a 200mm wide grid with ten channels.
Astro 2 - provides two 100mm wide grids each with five channels.
Astro 3 - provides five 40mm wide grids each with two channels.
Astro 4 - provides ten 20mm grids each with 1 channel.
• Press the [RUN/HALT] key to halt the chart .
Later on, we'll program these keys to contain customized charts.
The Dash 10 allows you to design exactly the grid you want. Let's try to design a grid.
• Press the [SYS] key. The SYS menu will appear.
SYS MENU
: MODIFY
: SETUP
: CHART
: CAPTURE
: DLOGGER
:
: CHANS
:
• Press the soft key above "MODIFY CHART". The MODIFY CHART menu
will appear.
• Press the soft key above "CHANGE GRID". The CHANGE GRID menu will
appear.
• Press the soft key above "TYPE" to change between standard and t -based grids.
standard -grids are printed in standard 5mm increments and are not
synchronized with the recorders timing marks.
t-based - grids are time-based grids printed with divisions that
are synchronized to the recorder's timing marks.
• Press the soft key above "LAYOUT GRIDS". The LAYOUT GRIDS menu will
appear.
LAYOUT GRIDS MENU
: CHANNEL
: STATUS
: MAJORS
:
By pressing the soft keys above/below "CHANNEL", "STATUS", "SIZE",
"POSITION", "MAJORS" and "MINORS", and turning the encoder wheel to get
the desired settings, you can customize your grids. Let's practice setting up grid.
• Press the soft key above "CHANNEL".
• Turn the encoder wheel until channel 2 is selected.
• Press the soft key above "STATUS" until it reads ON. Make sure that channel
2 is the only channel where the "STATUS" is ON.
• Press the soft key above "SIZE".
• Turn the encoder wheel until 100mm is selected. This changes the size of the
grid to 100mm.
• Press the soft key above "POSITION".
: SETUP
: SYSTEM
: TRIGGER
: I/O
: TOP OF
: PAGE
: FORM
: EJECT
: SIZE
:
: MINORS
:
: DISK
:
: I/O
:
: EXIT
:
: POSITI ON
:
: EXIT
:
5