ASTRO-PHYSICS 400GTO Інструкція з монтажу Посібник з монтажу - Сторінка 13

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Телескоп ASTRO-PHYSICS 400GTO. ASTRO-PHYSICS 400GTO 13 сторінок. German equatorial with servo motor drive

Друкувати сторінку

If you look into the black encoder housing, you will see the encoder itself mounted at the rear of the housing. When the

installation procedure is complete, the encoder shaft will insert into the center hole of the R.A. axis adapter. This allows the

encoder to read the motion of the R.A. shaft as the right ascension axis moves.

Now thread the R.A. encoder housing onto the R.A. axis housing. You may need to wiggle the encoder housing gently to

engage the shaft of the encoder (located within the R.A. axis housing) with the hole in the center of the R.A. axis adapter.

Tighten the 3 thumbscrews evenly to secure in place.

The hardware for your encoders is now installed. For actual set-up procedures for Micro MAX, Mini MAX or NGC MAX,

digital readouts refer to the relevant operating manual.

Periodic Maintenance

If you remove the R.A. encoder frequently, you may wish to use a very tiny amount of auto grease on the mating threads.