Canon EOS DIGITAL REBEL XT/350D DIGITAL Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Програмне забезпечення Canon EOS DIGITAL REBEL XT/350D DIGITAL. Canon EOS DIGITAL REBEL XT/350D DIGITAL 5 сторінок. Expodisc custom white balance procedures
Також для Canon EOS DIGITAL REBEL XT/350D DIGITAL: Інструкція з експлуатації (42 сторінок)
Друкувати сторінку
Canon 5D/5D mk II/5D mk III
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the "P", "S" or "A"
modes or set the correct manual exposure in "M" mode.
3. Aim the camera towards the light illuminating the subject and press the
shutter release button.
4. Push the ʻMENUʼ button
5. Scroll down to ʻCustom WBʼ in the menu using the thumb dial, then push the
ʻSETʼ button in the center of the thumb dial.
6. Push the ʻSetʼ button again to select the ExpoDisc ʻgray frameʼ just taken. A
reminder message will appear if the camera is not in ʻCustom WBʼ mode.
7. Select ʻOKʼ and the data will be imported.
8. Push the ʻMENUʼ button to exit the menu.
9. Push and hold the ʻAF-WBʼ button on top of the camera while rotating the
thumb dial to select the ʻcustom WBʼ icon (
10. Remove the ExpoDisc, return the camera to Auto Focus if desired, and start
shooting.
Canon 1D and 1Ds
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the "P", "S" or "A"
modes or set the correct manual exposure in "M" mode.
3. Aim the camera in the appropriate direction for the given lighting condition
and press the shutter release button. See the ExpoDisc Instruction Manual or
Quickstart Instructions for more information on where to aim the camera.
4. Press and hold the "MENU" button while turning thumb dial to select the
camera icon, then release "MENU" button.
5. Press and hold the "SELECT" button while turning thumb dial to select
"Custom WB", then release the "SELECT" button.
6. Press and hold the "SELECT" button while turning the thumb dial to select the
desired ʻgray frameʼ just taken, then release the "SELECT" button.
7. Press and hold the "SELECT" button while turning the thumb dial to select
"OK", then release "SELECT" button to import the ʻgray frameʼ white balance
data.
8. Press and hold the "WB" button while turning the thumb dial to select the
custom WB icon in the control panel located below the LCD screen, then
release the "WB" button.
9. Remove the ExpoDisc, return camera to Auto Focus if desired, and start
shooting.
Copyright, 2010 ExpoImaging, Inc.
"Canon" and the Canon camera models listed are Trademarks of Canon, Inc.
) in the control panel.