Akyga 5901720134974 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Джерело живлення Akyga 5901720134974. Akyga 5901720134974 4 сторінки.
Друкувати сторінку
AK-L1-025 - user manual
In case of any doubts regarding operation, safety or connection of the product, please contact
ź
the manufacturer or a qualified specialist for this purpose.
All maintenance, adjustment and repair work on the product may only be carried out by a
ź
qualified person in a specialist facility.
Removing the most common problems
Problem
The
LED strip or other
connected via
device
power supply does not
work
The LED strip lights
poorly
How to choose the LED power supply correctly?
In order to properly match the power supply with the LED strip, multiply the length of the strip
expressed in meters by the power of the tape, and then select the power supply with a margin of
min. 10% to guarantee long and trouble-free system operation, unless the manufacurer of the
LED strip recommends otherwise.
Connecting the LED Strip to the Power Supply:
1.
If LED strip doesn't have attached locking connectors prepare 0.5 mm² cables or special LED
connectors with cables.
2.
Solder cables to LED strip or attach special LED connector on LED strip in the points
intended for this.
3.
Screw the cables from the LED strip to the LED power supply using the COM (pin 4, 5) and
+ V (pin 6, 7) screw connectors according to the polarity.
4.
WARNING! For larger LED lighting installations, it is recommended to divide the strip into
smaller sections.
5.
The LED strip in RGB version needs RGB controller.
Cause
No mains voltage
The power adapter is
overloaded
Incorrect connection of
the device
There is a suspicion of a
product defect
The power adapter does
not correspond to the
current parameters
Solution
Check the correct connection of
ź
the power supply to the energy
grid
Check the mains fuses
ź
Disconnect the power adapter
ź
from energy grid, check the
correctness of the current
parameters
Make sure that the power
ź
supply is correctly connected to
the power grid
Check that the cords are well
ź
embedded in the connectors
Stop using and contact the
ź
seller
Check corresponds of the
ź
power of the LED strip to the
power supply
p. 3