Daema DWF-7688KG Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Пральна машина Daema DWF-7688KG. Daema DWF-7688KG 10 сторінок.

Water inlet installation

Tap selection

Suitable tap

The front end should be longer than 10mm The tap exit end face

should be flat and smooth, if not file it to avoid leakage

Connect the inlet hose connector with the tap

1、Press the lower end of the lock lever and push down the slider, take off the inlet hose

connector from the inlet hose, see illustration 1.

2、Loosen the four bolts on the inlet hose connector till the tap can be accessed, then

set the inlet hose connector in the tap, see illustration 2.(if the tap caliber is too larger and

could not set the inlet hose end, unscrew the four bolts and take out the bushing, tap exit

end must flat, otherwise it will leak, see illustration 3)

Inlet hose connector

Slider

Inlet hose

Illustration 1

3、Fasten the four bolts in the inlet hose connector evenly, see illustration 4.

4、Twist the fastening nut as the illustration ,see illustration 5.

Remark：before twisting the nut, the threading is about 4mm above the upper surface of the nut, after twisting,

the threading is less than 2mm above the upper surface of the nut, see illustration 6.

Illustration 4

Not suitable tap

Bushing

Screwdriver

Illustration3

Illustration 2

Before twisting,about 4mm

After twisting,less 2mm

Nut

Illustration 5

Illustration 6

Control panel instruction