Dorex DX2 FW Інструкція з монтажу Посібник з монтажу - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Система відкривання дверей Dorex DX2 FW. Dorex DX2 FW 16 сторінок.
Друкувати сторінку16. INSTALL ROD GUIDES AND COVERS WITH SCREWS
Latch Cover Screws
Latch Cover
Rod Guide
Rod Guide Screws
Cover
Cover
Screws
I
Position rod guides midway between latches and center
case, centered on rods. Mark, drill/tap and fasten rod
guides with two(2) screws.
CUT TOP ROD / EXTEND TOP ROD
CUT TOP ROD
Cut off from flat
end of rod
Step 1: Rod must be shortened if door height is less than 84". Make sure
that the rod is shortened (cut-off) on the flat end of the rod.
Step 2: Tap #1/4-20; 1" deep.
EXTEND TOP ROD
Top Rod
If door height is more than 84", the top rod can be extended (special order)
using an rod extension adaptor, two spring washers and a second rod with
threaded holes at both ends.
I
D
Install rod guide
at mid point
between latches
and center case.
Extension Rod
Adaptor
Spring/Lock Washer
Amount
to
Cut Off
84"
(2133 mm)
USING DEFAULT
VERTICAL RODS
FOR 7FT DOOR*
Actual
Door
Opening
Height
Example:
Amount to cut-off = 84" - (Actual Door Height)
(*) If exit device is installed at location as shown on p.5
10 / 16
TOP ROD
AVAILABLE
LENGTHS
23 ²⁷/32"
(605 mm)
48 ¹⁄8"
48 ¹⁄8"
(1221 mm)
(1221 mm)
36 ¹⁄8"
(916 mm)
For 7'
For 8'
For 10'
High door
High door
High door