Canon LV-7355 Посібник користувача - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Canon LV-7355. Canon LV-7355 48 сторінок. Canon owner's manual multimedia projector lv-7355 lv-7350
Також для Canon LV-7355: Брошура та технічні характеристики (2 сторінок)

Друкувати сторінку

BASIC OPERATION

Complete peripheral connections (with Computer, VCR, etc.)

before turning on projector. (Refer to "CONNECTING

PROJECTOR" on page 11~13 for connecting the equipment.)

Connect the projector's AC Power Cord into an AC outlet. LAMP

Indicator lights red, and READY Indicator lights green.

NOTE : When "On start" function is ON, this projector is turned

on automatically by connecting AC Power Cord to an

AC outlet. (Refer to pages 35, 36.)

Press POWER ON-OFF button on Top Control or on Remote

Control Unit to ON. LAMP Indicator dims, and Cooling Fans

start to operate. Preparation Display appears on a screen and

the count-down starts. The signal from PC or Video source

appears after 30 seconds.

Press POWER ON-OFF button on Top Control or on Remote

Control Unit, and a message "Power off?" appears on a screen.

Press POWER ON-OFF button again to turn off the projector.

LAMP Indicator lights bright and READY Indicator turns off.

After the projector is turned off, Cooling Fans operate (for 90

seconds).

When the projector has cooled down, READY Indicator lights

green again.

NOTE : Projector cannot be turned on during cooling period with

READY Indicator off. You can turn it on again after READY

Indicator lights green.

TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN

PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE

TURNING IT OFF.

DO NOT DISCONNECT AC POWER CORD BEFORE

READY INDICATOR LIGHTS GREEN.

note on operation

When "Power management" function is ON, the projector detects signal interruption and turns off Projection Lamp

automatically. Refer to "Power management" on page 36.

When WARNING TEMP. Indicator flashes red, the projector is automatically turned off. Wait at least 5 minutes before

turning on the projector again.

When WARNING TEMP. Indicator continues to flash, follow the procedures below:

1. Press POWER ON-OFF button to turn the projector off and disconnect AC Power Cord from an AC outlet.

2. Check Air Filters for dust accumulation.

3. Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 40.)

4. Turn the projector on again.

If WARNING TEMP. Indicator should still continue to flash, contact the sales dealer where you purchased this projector or

service center.

TURNING ON / OFF PROJECTOR

TURNING ON PROJECTOR

TURNING OFF PROJECTOR

Preparation Display disappears after 30 seconds.

Power off?

Message disappears after 4 seconds.