DORMA-Glas UNIQUIN Інструкція з монтажу - Сторінка 16
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень DORMA-Glas UNIQUIN. DORMA-Glas UNIQUIN 20 сторінок.
Друкувати сторінкуDORMA-Glas
6.4
Mount cover profiles
Requirements
• The unit components are correctly mounted.
• The cover profiles are prepared and cut to length as needed (see
Chapter 5.4).
• The silicone seals are attached to the cover profiles.
1.
Remove the spacers from the joints between 2 fixed elements.
Fig. 38
Remove the spacers between 2 fixed elements
NOTE
To meet the requirements of a sound insulation unit, it
is imperative to siliconize the joints as described.
NOTE
• For silicone use a permanently elastic and UV-
resistant silicone.
• Use an LSG-compatible silicone to siliconize LSG
glazing.
2.
It is recommended that the joints between 2 fixed elements
are siliconized along their entire length.
3.
If necessary, cut the vertical cover profiles to size as needed.
4.
For mounting a joint on the vertical cover profile, saw out a 15
mm x 15 mm recess on the glass side
(Fig. 39).
5.
Deburr all edges using the correct methods.
16
UNIQUIN Mounting profile
WN 059546 45532
NOTE
• The recess allows the mounting of the cover profile
without tilting with the abutting base profile.
• The recess is no longer visible after mounting the
adjacent cover profiles.
• If necessary, power or data lines can be routed
through the recess.
6.
Attach the prepared cover profile to the abutting edge of the
base profiles.
Fig. 39
Saw out a recess e.g. on the vertical cover profile at the lower joint
edge
7.
Attach the other cover profiles.
Fig. 40
Example of attaching a vertical cover profile with recess above
8.
Cut the horizontal cover profiles to length if necessary and
attach.
9.
Follow the system manual.
The mounting of the unit is completed.
»
Mounting
6.
4.
2023-08 / 16676